Chantilly, VA

Plumbing Parts Installation: Returned to install customer-supplied faucet

Gathering materials list to complete job

Maintenance performed: A preventative maintenance inspection was performed on the furnace. The air filter was replaced. All combustion components, including the burners and inducer motor, were inspected and are functioning correctly. The gas valve and control pressure were checked and verified to be within manufacturer specifications. The blower motor and wheel were inspected, and the ductwork was examined for any apparent issues. All components were found to be in good working order. Recommendations and actions: A soiled blower wheel was noted and recommended for cleaning. Additionally, the humidifier panel was recommended for replacement. The customer approved and paid for both services. The blower wheel was cleaned and the humidifier panel was replaced.

Arrived onsite, performed plumbing maintenance check and found multiple areas of concern. Kitchen faucet hot & cold angle stop valves have seized and cannot be operated. The supply lines connecting the valves to the kitchen faucet are very poor quality and are likely to burst. In powder room bathroom, lavatory faucet hot side angle stop valve has seized and cannot be operated. Also minor leak on lavatory sink p-trap nut. In the 2nd floor hallway bathroom, lavatory sink drain is actively leaking and needs to be replaced along with the pop up assembly. Customer also wanted quote for customer supplied showerhead in hallway bathroom. Adjusted both 2nd floor toilet tank water level while onsite.

During routine heat pump maintenance, the following components were inspected and found to be operating within normal parameters: Blower motor and wheel: The blower motor was tested for proper functionality and amp draw. The blower wheel was inspected for cleanliness and proper alignment. Ductwork: Visual inspection of the duct system confirmed proper airflow and no major leaks were detected. Contactor: The contactor was inspected for any signs of pitting or wear to ensure reliable operation. Capacitor: The capacitor readings were tested and verified to be within the manufacturer's specifications. Refrigerant level: The refrigerant charge was checked and confirmed to be at an adequate level. Recommendations: To mitigate the risk of damage from power surges, it is recommended to install surge protection devices (SPDs). Install an SPD on the ECM motor: The electronically commutated motor (ECM) is vulnerable to damage from voltage spikes. A plug-in style transient protector, such as

Havent done a site visit, working off of pictures from andrews job #

I arrived at my customer home for a one system heat inspection age 2013 outside temperature reading 60 degrees at this time customer like his/her thermostat set between 65/80 degrees in the home I adjusted customer thermostat five degrees above the room temperature in heat mode customer provided all air filters 240v 10kw reading 20.5 amps,indoor coil clean, filter clean blower motor clean, ez trap working,Uv light working, supply temperature 130.4 degrees, return temperature reading 74.8 degrees outside fan motor reading 0.9 amps,compressor reading 6.4 amps, 45+5uf dual capacitor reading 44.9 uf, outdoor compressor overheating will run get hot shut down and start up when cool off I recommend a replacement of the compressor and fuses or a replacement of the full system due to age system working at this time.

Fixed leaking toilet

2015 80% carrier infinity furnace Model Number 58CVA090- - - 16116 Serial Number: 3715A21508 System Overview: The 2015 Carrier Infinity gas furnace and air conditioning system were inspected for performance, safety, and efficiency. The system is operating properly, but several maintenance items were recommended to improve performance and protect system components. Top Concerns Here are the top areas where we feel your system needs attention: •Blower Wheel Cleaning – The blower wheel has visible buildup restricting airflow and efficiency. Cleaning will help restore proper airflow and system balance. •Blower ECM Surge Protector – Recommended to protect the ECM motor and control board from voltage spikes and surges, helping prevent costly electrical damage. •1 Zone Duct Cleaning – No duct leakage was found; however, ducts contain dust and debris buildup. Cleaning will improve airflow and indoor air quality. Component Summary • Thermostat: Functional and capable of utilizing

Thank you for your interest in our services. Based on our survey and our discussions James Vito, Inc. will provide the necessary labor and material to complete the work as specified below. SCOPE OF WORK: Replace one toilet from pre 1992 (3.5 gallons per flush, no longer manufactured), replace one American Standard ‘Cadet’ toilet tank, and rebuild one toilet tank. • Shut off water at angle stops. • Remove toilet and set new American Standard ‘Cadet’ toilet ADA compliant. • Remove toilet tank on the existing American Standard ‘Cadet’ toilet and install new tank. • Remove tank and install Fluidmaster rebuild kit (fill valve, flush valve and tank to bowl gasket and bolts). • Test for leaks. • Clean up work areas and haul away all job-related waste and debris. NOTES: • All work is to be performed during normal working hours M-F, 7AM to 5PM. • All work performed will meet federal, state, and local codes. • If a closet flange repair is necessary additional fees will apply

Two toilet tanks and one rebuild

HEAT MAINTENANCE CHECK: I checked and replaced the filter with one that the client provided. I checked the indoor blower wheel motor and housing compartment. Amps within spec. I checked electric heater kit and found working normally. I checked temperatures got a 40 degree temp rise. I checked all wiring and connections and all limits and safety’s working properly. I checked air scrubber working normally. I checked outdoor condenser unit and found weeds going into the unit, coils need to be cleaned. I checked all parts and found capacitor is getting weak and loosing tolerance. The contactor has burn marks on it and in bad shape. A lot of parts are no longer reliable. Overall this unit is aging and reaching its life expectancy and although the unit is performing right now, I recommend the client start thinking about replacing the system in the near future. There are some quotes that I left for the client so the unit can be kept up to date or she can receive a free estimate from one of o

Arrived onsite, customer stated he has been experiencing issues with 2 toilets on 2nd floor. Hallway bathroom toilet had a ballcock/float valve. I recommended a major rebuild, installing a fill valve, flapper replacement, and trip lever replacement. Master bathroom toilet had clogged jets, so I recommended toilet replacement. Customer does not want to move ahead with any work today, but will call back if issues persist. Both toilets flushed fine while I was onsite.

HVAC Maintenance: 2006 Daikin 80% Furnace During today’s inspection, I found the system operating but with areas that need attention to maintain efficiency and indoor air quality: • Temperature Rise: 58°F, which is within acceptable range for this furnace. • Evaporator Coil: No signs of leaks, corrosion, or damage at this time. • Air Filter: Replaced with client-provided filter. • Air Ducts: The ductwork is heavily polluted with dust and debris. A professional duct cleaning is recommended to improve airflow, system efficiency, and overall indoor air quality while also reducing strain on the furnace. • Blower Wheel & Motor: Motor is drawing 5.8 amps. The blower wheel has significant buildup and should be professionally cleaned. A clean blower wheel ensures proper airflow, better efficiency, and reduced stress on the motor. • Control Board: Communicating properly with the system; terminals are receiving 24V as designed. • Flame Sensor & Ignitor: Flame sensor has been clean

Water heater in ceiling 12 foot to base. Customer wants to drain it and abandon it in the ceiling then install new one in janitors closet.

Water heater was installed in 2022 Pilot light was off tried to relight pilot After lighting had a total of 5 flashes meaning we have bad gas control valve Shut water off to heater and drain down once drained shut gas off to the heater And remove pipe work once remove started removing old gas valve Then tape and dope new gas valve and tighten in place once tighten Reconnect gas line and let system fill with gas then turn water on and test for leaks once no leaks are present Light pilot clean up work area and all work related materials Note: 40 day warranty

Water heater was installed in 2022 Pilot light was off tried to relight pilot After lighting had a total of 5 flashes meaning we have bad gas control valve Shut water off to heater and drain down once drained shut gas off to the heater And remove pipe work once remove started removing old gas valve Then tape and dope new gas vlave and tighten in place once tighten Reconnect gas line and let system fill with gas then turn water on and test for leaks once no leaks are present Light pilot clean up work area and all work related materials Note:40 day warranty Water heater was installed in 2022 Pilot light was off tried to relight pilot After lighting had a total of 5 flashes meaning we have bad gas control valve Shut water off to heater and drain down once drained shut gas off to the heater And remove pipe work once remove started removing old gas valve Then tape and dope new gas vlave and tighten in place once tighten Reconnect gas line and let system fill with

Commercial Property Back Flow Preventer Testing: Got to job and filled out the appropriate paperwork and tags. Went into the sprinkler room and found assemblies, according to the tags, had just been tested. I Called Riad who decided that we did not need to test the assemblies.

Job Description: customer wants duct vent cleaning, gave her ballpark of $897-1,065 from our website. she has 1 zone

WATER IN THE PAN AGAIN: Found clogged drain line underneath the hvac system. I cut the pvc and flushed line set up and down. Eventually line got unclogged and water started flowing. I tested condensate line with approximately 3 gallons of water and added a few condensate tabelts to ensure proper drainage. I vacuumed all standing water with shop vac and repaired condensate line.

Thank you for your interest in our services. Based on our survey and our discussions James Vito, Inc. will provide the necessary labor, material to complete the work as specified below. SCOPE OF WORK: Replace American Standard Assisted flush toilet on fourth floor. • Turn off water to toilet at angle stop. • Remove existing toilet. • Set new American Standard Assisted flush toilet. • Test for leaks and caulk. • Clean up work area and haul away all job related debris. NOTES: • Clear access to the work area must be provided the day of the scheduled work. • All work to be performed during normal working hours (M-F) 7AM to 5PM excluding holidays • Requests for additional work or items requested will result in an authorized change order and additional costs. • All work performed will meet federal, state, and local codes. EXLUSIONS • No warranty on any existing equipment, piping or wiring not changed or updated by Vito Services. • James Vito Inc does not do asbestos remova

The AC maintenance inspection was conducted on a 2019 AC/furnace system. The indoor unit was found to be clean, and the UV light is currently lit; however, the timer on the UV light has expired, though the bulb itself is still functioning properly. The customer requested to order a replacement bulb to have on standby for when the current one eventually fails. The indoor coil showed no signs of rust, and the air filter was inspected but did not need to be replaced. The condenser unit was also checked, and no issues were found with the starting components. It was noted that the outdoor coil would benefit from being rinsed with water to help maintain system efficiency. Additionally, a bush near the condenser unit needs to be trimmed to ensure proper airflow. The customer was signed up for a VIP membership during the visit, and payment was collected via check. Overall, the system is performing well with only minor maintenance recommendations.

The AC maintenance inspection was performed on a 2018 AC/furnace system. Upon evaluation, the indoor unit was found to be clean, and the UV light is functioning properly. The indoor coil showed no signs of rust, and the air filter was replaced during the visit. The condenser unit was also inspected, and no issues were found with the starting components. However, it was noted that the outdoor coil would benefit from a rinse with water to help maintain system efficiency. Overall, the system is in good condition with no major concerns at this time. Signed customer up for VITO VIP membership. View visual findings from this job here - https://vitoservices.com

Job Description: Toilet on the 4th floor is leaking - Arrived at location for leaking toilet. Flushed toilet and leaking from the bottom and top as well. Took the toilet off and noticed there has been repairs to this broken flange both sides are broken. Used a flange repair kit, put new wax on and sat the toilet. Repair the toilet tank gasket as well but water kept leaking out, put my flash light on there and noticed there is a crack by the p trap section in which the toilet needs to be replaced. Customer will like a quote sent over

Job Description: Make proper notifications and turn the water the irrigation off. 2. Perform a complete rebuild using genuine Watts rebuilding new parts. 3. Reassemble and retest, report passing test result to Fairfax water. Arrived. Rebuilt backflow preventer system for the irrigation. Tested for Proper Functionality.