Hyattsville, MD

No Heat Call: I arrived at my customer home for water leaking from a convector I did a full system check and find water leaking from the service valve I removed and replaced one service valve five minutes system working properly at this time.

arrived on site to winterize a house that is being rebuilt, there were 7 drains to put antifreeze into and a water heater to drain, dumped antifreeze in all drains on 3 floors and pumped the heater dry, double checked the house to make sure there weren't any more drains, covered the toilet to not be used again, cleaned up work area and left

Call to maintenance on 2010 80% Furnace/ 2020 AC. Checked all components for proper operation found no issues with components. Secured any loose wires and checked for dirt and debris. Found blower is dirty and needs to be cleaned. Thoroughly checked heat exchanger and performed combustion and analyzer test. Found system is with in specs. Recommended adding Air scrubber to system after duct cleaning to keeps ducts and air clean. Also recommended replacing Furnace and water heat because of age and condition of system. Customer want to do both at the same time at a later date. Final cycled system at this time system is operational.

No Heat Call: after replacing bad condensate pump I completed a Co test and found ppm over 4700. I shit system off. customer is leaving country and will be back first week of December and would like comfort advisor to come out then.

Commercial Plumbing Call Install Pumps: customer notified us that they had two submersible pumps that needed to be replaced. pumps have arrived and ready to be installed. once on site set up equipment and began disassembling the old existing pumps. first we made sure that all power was off to the pumps before touching any wiring all power to the pumps is now off. the pumps where piped in 2inch schedule 40 piping. unwired both pumps from the control panel and used sawzall to cut out old sections of the existing line. used a strap with a hook at the end to attach to the pump from the handle in order to pull and sat the pump with out out using the chain fall. once both pumps where out of the pit. we then started to assemble to the new pump. once new pumps where ready to be dropped back down we then ran the lead wires to the control box to check for rotation on the pumps before placing them inside of the pit. both pumps rotation was correct. sat new pumps in place and test for leaks o

Local Commercial Plumber, Cracked Sewer Line: arrived onsite, 4" horizontal cast iron main drain line cracked. dug out pipe and undermined. cut pipe after cinder block wall where crack was located and cut on other side of wall to leave enough room for combo fitting. felt underneath pipe and looked inside to make sure we cut after the crack. used grit cloth and wire brush to clean off all scale and dirt on outside of pipe. also used hammer and chisel to break off scale that we couldn't get with grit cloth and scotch Brite. slipped ferncos on both ends of CI pipe and took measurements. pre fabricated new PVC pipe with combo wye cleanout and then put in place in ditch. asked Donnie how he wanted cleanout and then placed combo wye at 45 degree angle. tightened up both ferncos. noticed leak at farther end so needed to remove sheer band because it was compressing pipe too much. tightened up fernco and made sure there was no leak. installed 12" piece of pipe in center outlet of combo then cem

Clogged Sink That Drains Into Basement: Examined area of concern by customer. Laundry sink is backed up in basement from kitchen sink above. Gave customer investment option to restore flow in area. Customer told me what prior plumbers have said regarding line. Reiterated investment option today. Customer agreed. Ran approximately 25ft of drain cables through trap to restore flow in area. Smell strong odor of grease. Ran water full pressure through sink while pulling cables back with no backups. Viewed lint in cables and spoke to customer regarding situation. Continued running water with no backups. Flow is fully restored in area. Thank you for choosing Vito!

09/16/2024 customer advised that they have a sump pump that is tripping the breaker. once on site the customer advised me the pumps where installed about 7 -8 years ago and recently just had re piping done. there were 2 pumps present and pump number one was the pump that was tripping the breaker. went to put the pump in hand and it's instantly kicking the break off. pump number 1 was running about 14-15 amps and while pump 2 was running 4-5 amps. I then put pump 1 in auto and it stills kicks the breaker. no vibration, no sign of propellers spinning ,no water movement. on pump number 2 it's doesn't kicks the breaker off and also I can feel and hearing water being suctioned up through the pipes. also the engineer advised me that this pump cycles very very slow barely pulling water. upon further observation I observed that while pump number 2 was on its slowly pumping the water of the pit.xheck valves seems to be in good condition and I hear it open and closing when the pump it turned

Hydro-Jetting Commercial Plumbing Call: 09/13/2024 Got jet and went to the job. We made a few runs with the jet going 10 feet further each time and pulling back under pressure as well. the pit became too difficult to empty so we could jet properly. One of the pumps is burned up and tripping the breaker. It the one closest to the panel, it is pulling 14 to 15 amps for a minute and then it pops the breaker while not moving any water. The other pump is running at 4 to 5 amps continually under a load and moving the water. Lorenzo would like this looked at as soon as possible.

08/12/2024 Worked with Mizzel and the camera checking on the drainage line to the "sump pit" down in the boiler room. We did some testing with water and finally decided that this line may benefit from a jetting. Lorenzo liked the idea, I told him we would get it scheduled.

AC Maintenance 07/25/2024 SUMMER CHECK checked filter 16x25x1, checked indoor blower motor and wheel, checked condensate pan , line, with no trap or water safeties. checked temperature split return air temperature 77 , supply air temperature 58 , checked condenser motor and coil, checked contactor and capacitor found capacitor weak 45/5 MFD, checked outdoor air temperature 84 , discharge air temperature 100 , checked liquid line temperature 88 suction line temperature 56 . REPLACED CAPACITOR 45/5MFD 440 VOLTS CARRIER MODEL NUMBER 38TRA030320 SERIAL NUMBER 3301E24506

HVAC Call, It Is Taking 2 Hours For House to Get Cool 07/11/2024 Found a extremely dirty air filter 16x25x1 (I removed it temporarily customer must replace it today).

Commercial Plumbing Call Back Flow Preveter Tests 07/02/2024 Tested 7 backflows and they all passed.

07/01/2024 Arrived on site. Awaited inspection. Inspection approved. Joe to backfill. Confirmed with inspector steps to take for moving meter vault.

06/27/2024 I arrived at my customer home for ac not cooling Reservice from 06/25/24 I did a system check and find the screws needed to be tightened ac system working properly at this time.

06/26/2024 Retrieved material and arrived on site. Dug around pipe. Shut off water. Cut pipe and drained water. Pumped water out from excavation .Cleaned surface of pipe, lubricated gasket, and installed megalug cap. Turned on water and confirmed no leaks. Poured kicker.

AC Maintenance 06/25/2024 Furnace SN: 3402A46851 Condenser SN: 2020X49309 SA: 68.2F RA: 89.5F Delta T: 21.3F I was dispatched for a Maintenance Check. The AC system was on and cooling when I arrived. Furnace interior was clean and free of debris. Blower fan was clean and unobstructed. Clean filter, recently replaced. Drainage piping was secure. Ductwork was neat and secure. No issues to report inside. The outdoor condenser unit was one and running when I got to it. Contactor and capacitor are both performing highly, no cause for concern. Compressor is on and running correctly. Outdoor coil is clean. Entire system is on and functioning properly. No problems to report at this time.

Commercial Plumbing Call Disconnect Gas Water and Sewer From Building: 06/24/2024 Arrived on site. Shut off water to bathrooms. Dug down to discharge line of ejector pit. Cut and capped downstream end. Capped gas line.